(Pat Anderson) 3-18-05 - Daydream is just a fiberglass skin inside a mold at the C-Dory Factory in Auburn

(Pat Anderson)

(Pat Anderson)

(Pat Anderson)

(Pat Anderson) 3-25-05 - One week later, out of the mold, it's a boat now!

(Pat Anderson) 3-25-05 - Port side

(Pat Anderson) 3-25-05 - Over the transom

(Pat Anderson) 3-25-05 - The cockpit, no fuel tank yet

(Pat Anderson) 3-25-05 - Vee-berth area

(Pat Anderson) 3-25-05 - Vee-berth area, another view

(Pat Anderson) 3-25-05 - port side interior

(Pat Anderson) 3-25-05 - Front window cutouts

(Pat Anderson) 3-25-05 - Rear bulkhead from cabin

(Pat Anderson) 3-25-05 - Looking into cabin from cockpit through bulkhead window

(Pat Anderson) 3-25-05 - The new lid!

(Pat Anderson) 4-1-05 In the sand shop, getting ready to spray the interior

(Pat Anderson) 4-1-05 They drape the cabin and mask and tape all the openings.

(Pat Anderson) 4-1-05 Under the shroud

(Pat Anderson) 4-1-05 Vee berth, front windows and a bit of the ceiling

(Pat Anderson) 4-1-05 The vee berth

(Pat Anderson) The reading room *

(Pat Anderson) 4-1-05 View from the vee berth looking aft

(Pat Anderson) 4-1-05 And we have a gas tank now, 107 gallons (gulp!)

(Pat Anderson) 4-1-05 Taping up the transom