(AnchortownJim) Quick ASTER 500 mounting plate made out of 3/16" 6061 aluminum, prior to being epoxied to the deck with MarineTex, side view.
Viewed: 810 times.
|
(AnchortownJim) ASTER 500 mounting plate in plan view, prior to expoxying to the deck. The plate allows for easy removal of the windless for maintenance.
Viewed: 668 times.
|
(AnchortownJim) ASTER 500 installed, plan view.
Viewed: 676 times.
|
(AnchortownJim) ASTER 500 installed, port view.
Viewed: 652 times.
|
(AnchortownJim) ASTER 500 installed, starboard view.
Viewed: 670 times.
|
(AnchortownJim) Quick windless below deck.
Viewed: 746 times.
|
(AnchortownJim) View of Quick Aster 500 windless from the cabin
Viewed: 693 times.
|
(AnchortownJim) Windless control.
Viewed: 632 times.
|
(AnchortownJim) Windless control in my hand. The cord is long enough when passed through the open front window for me to operate it from the bow. It also has a built in line out counter. Very handy to know how much rode is out.
Viewed: 586 times.
|
(AnchortownJim) Close up of the plug for the windless control. You can easily disconnect the control if you want to. I leave it connected on the dash.
Viewed: 620 times.
|
(AnchortownJim) Pulled out the useless ice box beneath the helm seat. The object on the left is a Blue Seas Systems 8080 2 bank battery switch with a DC Breaker.
Viewed: 670 times.
|
(AnchortownJim) Glued a piece of 3/4" marine plywood to the hull with 3M 4200. Mounted the DC bus bars, one for the switched house circuits, one for non-switched and a common ground bus. This was driven by the installation of the windless.
Viewed: 739 times.
|
(AnchortownJim) The drawers I built to fill the void from the removed ice box. The fronts are made out of 3/4" Starboard.
Viewed: 729 times.
|
(AnchortownJim) The drawers have full extension slides.
Viewed: 710 times.
|
(AnchortownJim) Side view of drawer with added wood block for the retaining pins
Viewed: 653 times.
|
(AnchortownJim) Simple method to keep drawers from sliding open in rough seas, stainless steel pins
Viewed: 703 times.
|
(AnchortownJim) Nicro Vent 2000 Day/Night mounted in the hatch.
Viewed: 772 times.
|
(AnchortownJim) View of Nicro Vent in the hatch from the cabin
Viewed: 650 times.
|
(AnchortownJim) Paper towel holder held up with industrial strength double sided foam tape.
Viewed: 745 times.
|
(AnchortownJim) Trim Master trim tab on the port side.
Viewed: 689 times.
|
(AnchortownJim) Trim Master pump, mounted in the port lazerette.
Viewed: 679 times.
|
(AnchortownJim) Had to turn the trim tab through hull fittings 90 degree to clear the fuel tanks.
Viewed: 627 times.
|
(AnchortownJim) View of the location of the trim tab control switches, and the location of the windless on/off switch.
Viewed: 777 times.
|
(AnchortownJim) Quick windless solenoid mounted behind the engine throttle block
Viewed: 642 times.
|