Top support guide resting on a 3/4" temp. spacer to simulate the cabin setup.

Top slide for ac power panel cover. Made from a 3' piece of 3/4" oak finish stock from Home Depot. Datto is with a Dremel tool router bit set 3/16".

Side view of AC power panel top guide

Top view of top guide. Side view of bottom guide which are 2 - 3/4"pieces glued together for the 1 1/2" height needed to clear the breaker switches.

Pre-assembled AC power panel cover layout. Plexiglass is 0.093" standard stock cut to 8 1/2" x 4". Mounting hardware will be #10x2" brass wood screws chosen for initial setting, #10x3" bolts can replace them later if the screws don't hold up. Initial installation with screws is OK.

Small piece of wood under lower guide is a tempory spacer for these pixs. It represents the table support above the AC power panel which is also 3/4" thick.

The guides for the plexiglass stop abt 1/2" from each end of the 9" guides. The above pix is the bottom support guide.

AC POWER PANEL COVER completed

AC Power Panel cover_'a' view. Top guide base had to be hand notched for table top support mounting bolt. Top was placed abt 1/16" above bottom edge to allow enough support when mounting screw hole was pre-drilled.

AC Power Panel cover_'b' view. Plexiglass height was chosen for: [a] lower slide to be as high as possible to allow door under carpet to open as far as possible, [b] not to have slide cover any part of the power panel and [c] keeping the bottom circuit breaker blank space clear for a future addition.

AC Power Panel cover_'c' view. I allowed about 1/16" clearence between the plexiglass and the overall spacing between the slides to permit bending of the f'glass for installation.

AC Power Panel cover_'d' view.