Fishing sensor wires through rigging tubes. Very tight gasket where rigging tube enters engine (2 part base ring and SS clamp removed). Shift, throttle, gas lines and huge 12 power cords to starter all share this space. Plus maybe some other stuff. This section must be snaked through separately.
Viewed: 122 times.
|
tiny sensor wires to thread through rigging tubes
Viewed: 104 times.
|
Stealng Yamaha engine data with Lowrance adapter hack
Viewed: 98 times.
|
offseason deEdgestar dehumidifier set at 40 mounts on Garelick seat base stable.sized
Viewed: 122 times.
|
After poli-glow and 2 coats Pettit Hydrocoat bottomaint
Viewed: 130 times.
|
Sevview lightbar folds over, otherwise would exceed the same federal 13.5 ft hgt for big rig trucks
Viewed: 123 times.
|
replacement mount after prior one broke off with radar dome dangling over the side for 100 miles
Viewed: 95 times.
|
Camperback in Phifertex project allows breeze, insect protection
Viewed: 101 times.
|
Moderate rain protection, being sprayed with hose most sheets down
Viewed: 102 times.
|
before hosing
Viewed: 97 times.
|
During hosing
Viewed: 95 times.
|
Most hose spray sheets down
Viewed: 121 times.
|
AFter bottom job for $318...sponsons in Pettit Hydrocoat (1 gal, two ocats) 1 can Primocon then cans Pettit Alumaspray 2, $6 each on the gray market
Viewed: 147 times.
|
Galley extension over helm seat with 110AC outlet freed up after removing water heater and getting more storage cabinet space
Viewed: 297 times.
|