Hinge wood supports made from an old teak deck chair.
Viewed: 682 times.
|
Hinges are good quality stainless steel.
Viewed: 552 times.
|
Used Starboard as seat base, rubber patch prevents rubbing against fiberglass hull.
Viewed: 505 times.
|
|
|
The steps are removable and can be mounted either to port or starboard.
Viewed: 577 times.
|
The seats are actually the old hatch cover from inside on the port side.
Viewed: 538 times.
|
|
3 bolts with large washers hold the seats on.
Viewed: 530 times.
|
|
|
|
Fitting the hinges for the table. The wires that run athawartships between house and engine batteries fit nicely on top of the hinge supports.
Viewed: 340 times.
|
|
|
Since the hinge supports hold the wires up, no need for the screws for the old wire holders so I gel coated the screw holes.
Viewed: 313 times.
|
Table is made from starboard.
Viewed: 317 times.
|
|
Hinges with 3 coats of spar varnish on the supports. Ready to be mounted.
Viewed: 327 times.
|
|
Since I have trouble getting marks/stains off of starboard, I laminated the table with the same white laminate I used in the cabin around the sink/stove.
Viewed: 320 times.
|
With a heat gun, I bent a piece of flexible molding around the table for the rocking lip. Used a nail gun to hold it in place. Then putty for the nail holes.
Viewed: 337 times.
|
|
|