The C-Brats Forum Index
HomeForumsMy TopicsCalendarEvent SignupsMemberlistOur C-DorysThe Brat MapPhotos

 Cockpit Seating and Table Installation 
Hinge wood supports made from an old teak deck chair.
Hinge wood supports made from an old teak deck chair.
Viewed: 199 times.

Hinges are good quality stainless steel.
Hinges are good quality stainless steel.
Viewed: 158 times.

Used Starboard as seat base, rubber patch prevents rubbing against fiberglass hull.
Used Starboard as seat base, rubber patch prevents rubbing against fiberglass hull.
Viewed: 154 times.

Viewed: 171 times.

Viewed: 165 times.

The steps are removable and can be mounted either to port or starboard.
The steps are removable and can be mounted either to port or starboard.
Viewed: 222 times.

The seats are actually the old hatch cover from inside on the port side.
The seats are actually the old hatch cover from inside on the port side.
Viewed: 173 times.

Viewed: 178 times.

3 bolts with large washers hold the seats on.
3 bolts with large washers hold the seats on.
Viewed: 161 times.

Viewed: 163 times.

Viewed: 167 times.

Viewed: 165 times.

Fitting the hinges for the table. The wires that run athawartships between house and engine batteries fit nicely on top of the hinge supports.
Fitting the hinges for the table. The wires that run athawartships between house and engine batteries fit nicely on top of the hinge supports.
Viewed: 18 times.

Viewed: 13 times.

Viewed: 13 times.

Since the hinge supports hold the wires up, no need for the screws for the old wire holders so I gel coated the screw holes.
Since the hinge supports hold the wires up, no need for the screws for the old wire holders so I gel coated the screw holes.
Viewed: 15 times.

Table is made from starboard.
Table is made from starboard.
Viewed: 17 times.

Viewed: 11 times.

Hinges with 3 coats of spar varnish on the supports. Ready to be mounted.
Hinges with 3 coats of spar varnish on the supports. Ready to be mounted.
Viewed: 14 times.

Viewed: 11 times.

Since I have trouble getting marks/stains off of starboard, I laminated the table with the same white laminate I used in the cabin around the sink/stove.
Since I have trouble getting marks/stains off of starboard, I laminated the table with the same white laminate I used in the cabin around the sink/stove.
Viewed: 21 times.

With a heat gun, I bent a piece of flexible molding around the table for the rocking lip. Used a nail gun to hold it in place. Then putty for the nail holes.
With a heat gun, I bent a piece of flexible molding around the table for the rocking lip. Used a nail gun to hold it in place. Then putty for the nail holes.
Viewed: 20 times.

Viewed: 16 times.

Viewed: 13 times.

Powered by Gallery v1



Page generation time: 1532248641.77s (PHP: 100% - SQL: 0%) - SQL queries: 8 - GZIP disabled - Debug on