I installed this kicker bracket/swim step that I had fabricated
Viewed: 904 times.
|
Drilled my layout for bolts, then overdrilled for my thickened epoxy plug.
Viewed: 635 times.
|
taped the outside of the main bolt holes and drilled relief holes above, angled down
Viewed: 654 times.
|
made epoxy reservoirs for the inside, so that they fill to a level above the relief hols on the outside
Viewed: 658 times.
|
reservoirs
Viewed: 667 times.
|
Peeled off the tape on the reservoir, chiseled it flat (I\'m a good chisel guy. If you aren\'t a good chisel guy maybe use a sanding block)
Viewed: 658 times.
|
outside ready for faring and bolts
Viewed: 713 times.
|
inside ready for faring and bolts
Viewed: 725 times.
|