new seat overhangs a little due to motor controls but not enought to affect anything yet... *

new diesel heater being installed

winter installs need to clean up house a little

new magma rail mounts to make table stable. took 2 of them

did not want a pick up below water line so we have done this in the past with our boats, while not exactly hidden it has worked well and no worry about core damage.

shows overhang better but way nicer than what we had...

instal of heater, this is under sink and will plumb out

underside of starboard hatch mounted washdown pump just above gas tanks still have a few wires to reattach but should work well

combust air intake is up against hole that goes under gunnel on starboard side. it can suck fresh air like this or can grab and angle down and back to pull air from cabin

wash down hose ran better through boot than original plan. there is a hook on table I need to switch to this side and spray nozzel will hook onto

almost complete heater instal 1.5 gallon fuel tank and fuel pump

exhaust and muffler to thru hull. dry fit it 4-5 times put rv seal on it and one little corner folded maing it not fit the exhaust out on the heater result was one more cur and red seal all over white wrap...oh well

new kennwood marine speakers in first port side seat hopefully we can get music onto deck without blasting people in the cabin

finally all hooked up did not like the paper filter they sent with kit so waiting to get new one. need to figure out where to put all the exttra wire harness? was planning behind tank but it was smaller than i thought

heater thru hull. would of liked to gotten it al into the grey but under sink for some reason it wasn't flat all the way up...

cup holders flush mount into table

new 8 switch pannel blue sea

new 4 switch pannel on gunnel in cockpit

new blue sea breaker box

existing outlet i want to cut into

photo (8)

deck lights

cockpit switch

anchor 1