starting to make some connections inside
Viewed: 1118 times.
|
gaping whole left by previous work needs cleanup
Viewed: 1103 times.
|
Thats better and a good home for our ditch box plus a tackle box on top later
Viewed: 1178 times.
|
A peek at the new house batteries
Viewed: 1482 times.
|
port side (there are straps going both directions
Viewed: 999 times.
|
Installed a Wallas 1300 kerosene heater on the Stbd inside bulkhead
Viewed: 1121 times.
|
Through hull location for Wallas intake and exhaust
Viewed: 934 times.
|
top view
Viewed: 1238 times.
|
10L tank in underseat cabinet
Viewed: 938 times.
|
tank position
Viewed: 867 times.
|
ABS extension added
Viewed: 744 times.
|
This elbow slips on to direct all the warmth rearward to the cockpit table area
Viewed: 689 times.
|
Stbd wiring complete
Viewed: 905 times.
|
lots of room with batteries out of the way
Viewed: 872 times.
|
new anchor gear added and locker area repainted and sealed
Viewed: 870 times.
|
waterproof panel is first version of a divider between bedding and anchor gear
Viewed: 830 times.
|
attached with industrial velcro and worth a try before fiberglass is brought in
Viewed: 837 times.
|
Minn Kota Riptide ST55 I pilot
Viewed: 895 times.
|
low enough not to block vision much
Viewed: 877 times.
|
positioned in the only spot that would work well
Viewed: 846 times.
|
view of the anchoring alignment. not perfect but I have an idea for that
Viewed: 760 times.
|
overhang is required for clearance in the down position
Viewed: 813 times.
|
pull the quick release, lift, and this starboard block is all that remains on the deck
Viewed: 849 times.
|
Berth (AC powered) heater and wedge shaped controller is for heated mattress pad (DC or AC powered at 127 AC watts)
We plan to use it to preheat the bed and not to run overnight.
Viewed: 880 times.
|