Transducer block (before wire properly routed or secured). This is a 3/4" Starboard™ block. I over-drilled and removed a very generous amount of transom core, then painted with neat epoxy and then filled holes with thickened epoxy. After that cured, I drilled and tapped (into the thickened epoxy areas) for the bronze machine screws that secure the block to the transom. The bedding is an experiment with butyl (later I removed it and it was holding very tenaciously, but I have not tested it long-term yet).

After mounting the block, I tapped the Starboard for the transducer fasteners.

stove removed

Wallas open and control

NL map

Utah fishing license page

AZ license

stbd bow at dock

Yellow 16 spunky

Glimpse of "mockup" splashwell table I made, inspired by the ones on Halcyon, C-Cakes, and Kerri-On.

Glimpse of "mockup" splashwell table I made, inspired by the ones on Halcyon, C-Cakes, and Kerri-On.

Splashwell table on Halcyon. I modeled mine after this one, with one main difference, which is that mine just rests on the small lips inboard of each lazarette lid vs. covering the lids as this one does. So I have a bit less table width, but can get in and out of the lazarettes with it in place.

C-Doré PT

Lighter blue C-Dory 25 from Sportcraft Marina's website.

1993 C-Dory center console (console, etc. added recently)

1993 C-Dory center console (console, etc. added recently)

1993 C-Dory center console (console, etc. added recently)