Supposed C-Dory 12 (I think it may have been determined that it is really a 14)

Supposed C-Dory 12 (I think it may have been determined that it is really a 14)

Palm

Garmin Bluechart Data Card, fits in Garmin 2006c and numerous others.

plain fastener

shelf fastener

Brass stem guard dimensions, 2002 22 Cruiser. Where the stem ends aft is where the "keel" starts, so a rubber keel guard doesn't look like it could logically go any further aft.

Garmin data card packaging, with card sitting on top.

Under galley showing Wallas exhaust hose.

89 closure and detour

Wallas top

Wallas serial number

Wallas tank

Wallas exhaust hose

Wallas open and control

Photo used to ask if this is the location of cracks on a different C-Dory that a potential buyer is asking about.

Slot cut into galley face for Wallas ventilation

Nicely centered hole for Wallas control (ahem...)

IMG 6567

IMG 6568

Annoyed drain guard

Garelick operation *

Not the best photo - I'll try to get a better one in future. This is an alternative method of hanging the after fender. I got the idea from Will-C and wanted to try it since the fender hanging from the after cleat can tend to get aft of the boat. The basic idea is to put some sort of dowel into the rod holder (these were already in my boat) and then hang the fender from it. I started with Schedule 80 PVC pipe (1" IIRC), but didn't really like handling it, so this is an ash tool handle replacement (bought at Ace Hardware). To secure the fender whip to the dowel, I drilled a hole through the dowel, and then run the whip through it and then tie a figure-8 knot. That way it is adjustable if necessary. I left the dowel this long because it then keeps the whip/line off the gelcoat at the edge of the deck.

C-Dory cutaway hi res