testing fit Lewmar Pro Series 700H. Kerri On
Viewed: 956 times.
|
windlass switch next to trim switch
Viewed: 734 times.
|
Lewmar is providing better switches Up is up Down is down go figure
Viewed: 731 times.
|
Lewmar relay
Viewed: 808 times.
|
Lewmar relay bottom left easy access and allows wires from aft easy attachment
Viewed: 850 times.
|
easy access to switch yet protected
Viewed: 763 times.
|
using broom handle as strait edge to be sure I'm lined up
Viewed: 795 times.
|
check it 9 times and walk away between the times Get this part correct
Viewed: 788 times.
|
when the Force is strong with you cut the holes
Viewed: 770 times.
|
undercut and epoxy filled curing overnight
Viewed: 791 times.
|
taped around gasket (did not use it) to limit sealant spread to deck used 3M 4200 white
Viewed: 749 times.
|
bolted in place
Viewed: 748 times.
|
studs cut short and taped over to prevent injury if reaching in to adjust pile of rode power wires zap strapped to deck with a lot of extra length for ease of maintenace. (cut the strap)
Viewed: 747 times.
|
1/4 inch 12x12 UHDW plastic backing plate windlass load is in shear so maybe overkill but maybe not. lewmar provides 3/8 washers, not even fender washers
Viewed: 757 times.
|
loaded and tested and tied back 22lb Lewmar claw to 45 ft 1/4 Hi Test to 225 ft New England premium 3 strand with tapered back splice to the last link.
Viewed: 787 times.
|
I turned on every system in the boat and then cycled the windlass, nothing popped or quit, completed install
Viewed: 840 times.
|