Newly acquired 12ft C-Dory skiff

Reverse Chines like the big hulls

rib runs about half way forward

Check out the angle on the stern

The hull is overall in very good shape

Bow and stern corner seats are sealed with foam floatation and center bench is just an upside down U of fiberglass. Rear center board lifts out without fasteners

New logos added and licensed/titled now

2012-04-01 17.05.14

line guide on bow and cleat added by previous owner

Nearly flat floor nice for moving around

rear plywood filler lifts out and transom board notched for outboard clamps

New capacity plate ready for action behind acrylic

stern rolled edge cut off by first owner for mounting of outboard (I was told) and it really just needs some edge trim to make it look right

You can see the bulge near the stern corner where the balsa core runs across the transom for added strength

plywood filler board was held down prevously with velcro and there is some chipping of the gelcoat at the corner. It really needs another method of attaching the board here.

New cover working well with tent pole hoop under for water shedding

yep, it's a C Dory and all balsa cored

smaller logo and stripe plus trim tape added

2013-05-02 19.32.47

Turn Island in the San Juans. The boat would just barely plane and top out at 8 knots with that 4HP Yamaha and one person aboard. photo by Hardee