The C-Brats Forum Index
HomeForumsMy TopicsCalendarEvent SignupsMemberlistOur C-DorysThe Brat MapPhotos

 C-Dory 12ft skiff "Lola" 
Newly acquired 12ft C-Dory skiff
Newly acquired 12ft C-Dory skiff
Viewed: 1264 times.

Reverse Chines like the big hulls
Reverse Chines like the big hulls
Viewed: 1026 times.

rib runs about half way forward
rib runs about half way forward
Viewed: 999 times.

Check out the angle on the stern
Check out the angle on the stern
Viewed: 930 times.

The hull is overall in very good shape
The hull is overall in very good shape
Viewed: 933 times.

Bow and stern corner seats are sealed with foam floatation and center bench is just an upside down U of fiberglass.  Rear center board lifts out without fasteners
Bow and stern corner seats are sealed with foam floatation and center bench is just an upside down U of fiberglass. Rear center board lifts out without fasteners
Viewed: 1064 times.

New logos added and licensed/titled now
New logos added and licensed/titled now
Viewed: 987 times.

2012-04-01 17.05.14
2012-04-01 17.05.14
Viewed: 910 times.

line guide on bow and cleat added by previous owner
line guide on bow and cleat added by previous owner
Viewed: 863 times.

Nearly flat floor nice for moving around
Nearly flat floor nice for moving around
Viewed: 855 times.

rear plywood filler lifts out and transom board notched for outboard clamps
rear plywood filler lifts out and transom board notched for outboard clamps
Viewed: 909 times.

New capacity plate ready for action behind acrylic
New capacity plate ready for action behind acrylic
Viewed: 929 times.

stern rolled edge cut off by first owner for mounting of outboard (I was told) and it really just needs some edge trim to make it look right
stern rolled edge cut off by first owner for mounting of outboard (I was told) and it really just needs some edge trim to make it look right
Viewed: 886 times.

You can see the bulge near the stern corner where the balsa core runs across the transom for added strength
You can see the bulge near the stern corner where the balsa core runs across the transom for added strength
Viewed: 875 times.

plywood filler board was held down prevously with velcro and there is some chipping of the gelcoat at the corner.  It really needs another method of attaching the board here.
plywood filler board was held down prevously with velcro and there is some chipping of the gelcoat at the corner. It really needs another method of attaching the board here.
Viewed: 896 times.

New cover working well with tent pole hoop under for water shedding
New cover working well with tent pole hoop under for water shedding
Viewed: 876 times.

yep, it's a C Dory and all balsa cored
yep, it's a C Dory and all balsa cored
Viewed: 1070 times.

smaller logo and stripe plus trim tape added
smaller logo and stripe plus trim tape added
Viewed: 1048 times.

2013-05-02 19.32.47
2013-05-02 19.32.47
Viewed: 940 times.

Turn Island in the San Juans.  The boat would just barely plane and top out at 8 knots with that 4HP Yamaha and one person aboard.  photo by Hardee
Turn Island in the San Juans. The boat would just barely plane and top out at 8 knots with that 4HP Yamaha and one person aboard. photo by Hardee
Viewed: 881 times.

Powered by Gallery v1



Page generation time: 1711659452.07s (PHP: 100% - SQL: 0%) - SQL queries: 9 - GZIP disabled - Debug on