Grinding away the gelcoat. Note the pink foam core.
Viewed: 941 times.
|
The interior patched w/ poly resin/clothe & the hole filled w/ Duraglas.
Viewed: 768 times.
|
Exterior then ground out; poly resin/clothe then installed. Three layers; chop strand, clothe, chop strand.
Viewed: 715 times.
|
Repair was ground and layer of Duraglass skimmed over the convex.
Viewed: 692 times.
|
Coming along. This is prior to 2nd grinding, Duraglass skimming.
Viewed: 698 times.
|
The final sanding done. On to gelcoat.
Viewed: 697 times.
|
The Preval sprayer w/ thinned gelcoat w/ speed cure.
Viewed: 733 times.
|
Spraying done. Trust me; the holes are there. You just can't see them now!
Viewed: 715 times.
|
Next 600, then 800...then buffing. The gelcoat is a little bit rough in texture so I can see where the sanding is needed. Big thanks to Scott @ Triton for the gelcoat, catalyst and instructions.
Viewed: 706 times.
|
The next morning. The patches are now more visible and in some spots, wet still. The upper patch in the pic is NOT wet however, and is more opaque. It actually looks good, even up close.
Viewed: 702 times.
|
Patches became visible overnight. Both these are more "wet" than the other two. It has me confused.
Viewed: 722 times.
|
The repair is done. Came out OK; I'd give myself an 8/10. Not perfect but I did it myself.
Viewed: 657 times.
|
This is before the cutting/buffing.
Viewed: 718 times.
|
After the cutting & buffing. Shine seems pretty uniform. Although if you look carefully, you'll see the new gelcoat is not 100% perfect in color, probably due to age, sunlight etc. I'm happy w/ it though.
Viewed: 877 times.
|
Search
Private Messages
Profile
Log in
Register
Help