14 info from 2004 SBS

6ft roll of closed cell foam tape 5 inches wide and 1/8 thick

In this pic you can see how well the two strips of foam blend into the wall color

1117002050

Sealand Porta Potti now installed and plumbed in place of the original, less than wonderful, "marine head"

Vent through hull for potti has a chrome "look" exterior tucked up under the roof overhang.

potti with top tank removed to show plumbing connections to MSD fitting suppied with marine kit including hold-down brackets

Storage in place of old holding tank seen through new center transom hatch. It's a very large space for the stern anchor, stern tie line, and fenders.

looking left through center transom hatch into space not accessible with original holding tank in place

looking right through center transom hatch into space not accessible with original holding tank in place.

V berth dimensions including helm and co-captain wall and pass-thru measures

1/8th inch thick adhesive foam tape applied to overhead in v-berth

1/8th inch thick adhesive foam tape applied to overhead in v-berth

Twin 15s!

77 x 30 x .625 inch foam pad cut in half lengthwise and used to line the lower walls in the v-berth for insulation from the cold (but no longer wet) wall while sleeping. I always end up against the wall.

vberth pockets

0413001751

1.9 feet of water just northwest of the bouy next to the "9" sounding. We polished the prop tips and had to tilt the motors to get out of there. Felt like a sand bar but the water was too cloudy to see the bottom less than two feet down. Gotta love shallow draft boats.

works in the water and should come in handy for lots of tasks onboard

downsized 1107111520

downsized 1107111523 *

2012-06-24 12.39.58

2012-06-24 12.40.25

possible privacy room