The C-Brats Forum Index
HomeForumsMy TopicsCalendarEvent SignupsMemberlistOur C-DorysThe Brat MapPhotos

 NORO LIM Wallas 1300 Heater Installation 
Wallas 1300 Install - - DSC06129 Aft seat, shelving, & table; Heater to go where the shelving narrows - next to, and just forward of the aft seat.  Chose the Wallas 1300 model because it's the most compact, and because I already had a kerosene stove.
Wallas 1300 Install - - DSC06129 Aft seat, shelving, & table; Heater to go where the shelving narrows - next to, and just forward of the aft seat. Chose the Wallas 1300 model because it's the most compact, and because I already had a kerosene stove.
Viewed: 2029 times.

Wallas 1300 Install - DSC06130 View below the raised table.  Shelving will be removed here, and the outboard edge of the forward seat cushion (shown on the right) will be trimmed by about 1/2 inch to allow the table to hang just slightly further away from the hull to make room for the heater.
Wallas 1300 Install - DSC06130 View below the raised table. Shelving will be removed here, and the outboard edge of the forward seat cushion (shown on the right) will be trimmed by about 1/2 inch to allow the table to hang just slightly further away from the hull to make room for the heater.
Viewed: 1259 times.

Wallas 1300 Install - DSC06131
Wallas 1300 Install - DSC06131
Viewed: 1304 times.

Wallas 1300 Install - DSC06132 Checked and rechecked clearances.  It will be tight.  Checked with SCAN Marine who assured me mounting the heater like this would be fine.
Wallas 1300 Install - DSC06132 Checked and rechecked clearances. It will be tight. Checked with SCAN Marine who assured me mounting the heater like this would be fine.
Viewed: 1263 times.

Wallas 1300 Install - DSC06133 - 12V socket and table latch will also have to be moved.
Wallas 1300 Install - DSC06133 - 12V socket and table latch will also have to be moved.
Viewed: 1296 times.

Wallas 1300 Install - DSC06139
Wallas 1300 Install - DSC06139
Viewed: 1258 times.

Wallas 1300 Install - DSC06140
Wallas 1300 Install - DSC06140
Viewed: 1227 times.

Wallas 1300 Install - DSC06142 Made an
Wallas 1300 Install - DSC06142 Made an "L" shaped bracket and drilled it to match the Wallas hanger. Will allow mounting in a tight spot between the hull and the lowered table, with just enough clearance above for the intake/exhaust, and just enough below for the fuel and return lines.
Viewed: 1248 times.

Wallas 1300 Install - DSC06143 Ready to start drilling
Wallas 1300 Install - DSC06143 Ready to start drilling
Viewed: 1271 times.

Wallas 1300 Install - DSC06145
Wallas 1300 Install - DSC06145
Viewed: 1272 times.

Wallas 1300 Install - DSC06148
Wallas 1300 Install - DSC06148
Viewed: 1216 times.

Wallas 1300 Install - DSC06149
Wallas 1300 Install - DSC06149
Viewed: 1292 times.

Wallas 1300 Install - DSC06150
Wallas 1300 Install - DSC06150
Viewed: 1276 times.

Wallas 1300 Install - DSC06154 It fits.
Wallas 1300 Install - DSC06154 It fits.
Viewed: 1256 times.

Wallas 1300 Install - DSC06155 Ready for wiring, fuel lines, and intake/exhaust.
Wallas 1300 Install - DSC06155 Ready for wiring, fuel lines, and intake/exhaust.
Viewed: 1411 times.

Wallas 1300 Install -DSC06156 Remote switch connection to heater
Wallas 1300 Install -DSC06156 Remote switch connection to heater
Viewed: 1308 times.

Wallas 1300 Install -DSC06159  Remote switch is mounted on the side of the helm where it is easy to reach from the helm seat, First Mate's seat, or v-berth.
Wallas 1300 Install -DSC06159 Remote switch is mounted on the side of the helm where it is easy to reach from the helm seat, First Mate's seat, or v-berth.
Viewed: 1304 times.

Wallas 1300 Install -DSC06163 - Protection against inadvertently bumping the switch on or off made from a small scrap of 1/2
Wallas 1300 Install -DSC06163 - Protection against inadvertently bumping the switch on or off made from a small scrap of 1/2" starboard *
Viewed: 1326 times.

Wallas 1300 Install -DSC06158. Ten liter Fuel tank in place. Two extra fuel jugs will just fit in next to it (one is visible - with white cap).  Tie down straps to be installed.
Wallas 1300 Install -DSC06158. Ten liter Fuel tank in place. Two extra fuel jugs will just fit in next to it (one is visible - with white cap). Tie down straps to be installed.
Viewed: 1293 times.

Wallas 1300 Install -DSC06165.  Pieces cut for rebuilding the forward part of the shelving.
Wallas 1300 Install -DSC06165. Pieces cut for rebuilding the forward part of the shelving.
Viewed: 1280 times.

Wallas 1300 Install -DSC06171.  New shelving support assembled with power line connectors mounted.
Wallas 1300 Install -DSC06171. New shelving support assembled with power line connectors mounted.
Viewed: 1305 times.

Wallas 1300 Install -DSC06174.  New shelf support in place.
Wallas 1300 Install -DSC06174. New shelf support in place.
Viewed: 1269 times.

Wallas 1300 Install -DSC06175.  Wires connected.  (Note the extra right angle brace at the top of the hanger bracket.  Just a suspenders and belt move to make sure the heater stays put.)
Wallas 1300 Install -DSC06175. Wires connected. (Note the extra right angle brace at the top of the hanger bracket. Just a suspenders and belt move to make sure the heater stays put.)
Viewed: 1722 times.

Wallas 1300 Install - DSC06180.  Intake/exhaust installed. The heater warms the cabin nicely, whichever way the seats and table are configured.  The louvers on the vent can be turned to direct heat at the First Mate's feet, whichever seat she is in. Ducting could be added.
Wallas 1300 Install - DSC06180. Intake/exhaust installed. The heater warms the cabin nicely, whichever way the seats and table are configured. The louvers on the vent can be turned to direct heat at the First Mate's feet, whichever seat she is in. Ducting could be added.
Viewed: 2218 times.

* Comments available for this item.
Powered by Gallery v1



Page generation time: 1711707685.8s (PHP: 100% - SQL: 0%) - SQL queries: 9 - GZIP disabled - Debug on