Davit arm disassembled and stowed; honda generator gas tank in foreground
Viewed: 1916 times.
|
Davit in place with arm locked up
Viewed: 2205 times.
|
Bob and Marie
Viewed: 2592 times.
|
Excursion with Sea Frequency CD 25 ready to roll
Viewed: 2112 times.
|
Frequent Sea ready to come \"home\"
Viewed: 2145 times.
|
fungus growing on the edge of the hatch opening
Viewed: 2307 times.
|
edge with dry rot
Viewed: 2140 times.
|
stb hatch, middle hatches and cracks in deck
Viewed: 2198 times.
|
Cockpit deck with wet core removed on Port side looking foreward
Viewed: 2188 times.
|
Cockpit deck with core removed on Stb side looking foreward. The outer laminate seems more substantial: core will be undermined and new layers of glass will be placed over it.
Viewed: 2029 times.
|
Port side with undercut for fuel fill--this will be glassed into the new deck
Viewed: 2065 times.
|
Thin outer layer of glass mat on deck (this is upside down--and the balsa is wet--about 12\" from the hatch
Viewed: 2089 times.
|
Under deck glass, with baltek scrim--not well adherent to the deck glass.
Viewed: 1848 times.
|
Upper part of deck (where you stand, over the balsa, showing scrim--and a crack thru this thin laminate)
Viewed: 1918 times.
|
Rresaonably good balsa core, but with poor adherance to deck (upside down)--with poor adherence, there is less stenght. The water migration stopped at the line between two sections of Baltek
Viewed: 2051 times.
|
Nida-core replacing bad balas, with all gel coat ground off foreward and around edges
Viewed: 2042 times.
|
Nida-core cut out--cellular nature, will be epoxy filled at the edges even though water proof
Viewed: 1840 times.
|
12 oz biaxial cloth. Fibers oriented at 45 degrees, mat under for adhesion
Viewed: 1758 times.
|
Cockpit with biaxial glass over the Nida-core and balsa
Viewed: 1840 times.
|
Biaxial glass over the Nida-core and balsa
Viewed: 1774 times.
|
Nonskid surface rolled out on the new cockpit floor
Viewed: 1986 times.
|
epoxy sealing of edges of Nida Core
Viewed: 1726 times.
|
Transom area where depth finder transducer was placed drilled out looking for moisture
Viewed: 2004 times.
|
Transom opened up. Plywood minimal moisture and not affected. Balsa rot near the screw holes and moisture in core about 1 inch back
Viewed: 2356 times.
|