The C-Brats Forum Index
HomeForumsMy TopicsCalendarEvent SignupsMemberlistOur C-DorysThe Brat MapPhotos

 Thataway 
Davit arm disassembled and stowed; honda generator gas tank in foreground
Davit arm disassembled and stowed; honda generator gas tank in foreground
Viewed: 1115 times.

Davit in place with arm locked up
Davit in place with arm locked up
Viewed: 1304 times.

Bob and Marie
Bob and Marie
Viewed: 1604 times.

Excursion with Sea Frequency CD 25 ready to roll
Excursion with Sea Frequency CD 25 ready to roll
Viewed: 1242 times.

Frequent Sea ready to come \
Frequent Sea ready to come \"home\"
Viewed: 1327 times.

fungus growing on the edge of the hatch opening
fungus growing on the edge of the hatch opening
Viewed: 1490 times.

edge with dry rot
edge with dry rot
Viewed: 1342 times.

stb hatch, middle hatches and cracks in deck
stb hatch, middle hatches and cracks in deck
Viewed: 1371 times.

Cockpit deck with wet core removed on Port side looking foreward
Cockpit deck with wet core removed on Port side looking foreward
Viewed: 1378 times.

Cockpit deck with core removed on Stb side looking foreward.  The outer laminate seems more substantial: core will be undermined and new layers of glass will be placed over it.
Cockpit deck with core removed on Stb side looking foreward. The outer laminate seems more substantial: core will be undermined and new layers of glass will be placed over it.
Viewed: 1218 times.

Port side with undercut for fuel fill--this will be glassed into the new deck
Port side with undercut for fuel fill--this will be glassed into the new deck
Viewed: 1228 times.

Thin outer layer of glass mat on deck (this is upside down--and the balsa is wet--about 12\
Thin outer layer of glass mat on deck (this is upside down--and the balsa is wet--about 12\" from the hatch
Viewed: 1284 times.

Under deck glass, with baltek scrim--not well adherent to the deck glass.
Under deck glass, with baltek scrim--not well adherent to the deck glass.
Viewed: 1054 times.

Upper part of deck (where you stand, over the balsa, showing scrim--and a crack thru this thin laminate)
Upper part of deck (where you stand, over the balsa, showing scrim--and a crack thru this thin laminate)
Viewed: 1127 times.

Rresaonably good balsa core, but with poor adherance to deck (upside down)--with poor adherence, there is less stenght.  The water migration stopped at the line between two sections of Baltek
Rresaonably good balsa core, but with poor adherance to deck (upside down)--with poor adherence, there is less stenght. The water migration stopped at the line between two sections of Baltek
Viewed: 1226 times.

Nida-core replacing bad balas, with all gel coat ground off foreward and around edges
Nida-core replacing bad balas, with all gel coat ground off foreward and around edges
Viewed: 1195 times.

Nida-core cut out--cellular nature, will be epoxy filled at the edges even though water proof
Nida-core cut out--cellular nature, will be epoxy filled at the edges even though water proof
Viewed: 1066 times.

12 oz biaxial cloth. Fibers oriented at 45 degrees, mat under for adhesion
12 oz biaxial cloth. Fibers oriented at 45 degrees, mat under for adhesion
Viewed: 988 times.

Cockpit with biaxial glass over the Nida-core and balsa
Cockpit with biaxial glass over the Nida-core and balsa
Viewed: 1035 times.

Biaxial glass over the Nida-core and balsa
Biaxial glass over the Nida-core and balsa
Viewed: 1002 times.

Nonskid surface rolled out on the new cockpit floor
Nonskid surface rolled out on the new cockpit floor *
Viewed: 1055 times.

epoxy sealing of edges of Nida Core
epoxy sealing of edges of Nida Core
Viewed: 971 times.

Transom area where depth finder transducer was placed drilled out looking for moisture
Transom area where depth finder transducer was placed drilled out looking for moisture
Viewed: 1124 times.

Transom opened up.  Plywood minimal moisture and not affected.  Balsa rot near the screw holes and moisture in core about 1 inch back
Transom opened up. Plywood minimal moisture and not affected. Balsa rot near the screw holes and moisture in core about 1 inch back
Viewed: 1368 times.

* Comments available for this item.
Powered by Gallery v1



Page generation time: 1550271095.35s (PHP: 100% - SQL: 0%) - SQL queries: 8 - GZIP disabled - Debug on