Jervis Inlet, BC Canada - near Princess Louisa

(Sea Skipper) Sidney Spit, BC 1

(Sea Skipper) Sidney Spit, BC 2

(Sea Skipper) Point Hudson Marina 1 (Port Townsend)

(Sea Skipper) Point Hudson Marina 2 (Port Townsend)

(Sea Skipper) Pleasant Harbor, Hood Canal

(Sea Skipper) Pleasant Harbor, Hood Canal 2

(Sea Skipper) Pleasant Harbor, Hood Canal 3

(Sea Skipper) Pump House Rd., Near Yakima WA *

(Chaco Canyon, New Mexico) Off highway capable RV built by EarthRoamer.com on Ford F550 Chassis.

(Sea Skipper) Mount Hood Pass, Oregon

Near Ellensburg, WA.jpg

(Sea Skipper) Sidney Spit, BC 5

(Sea Skipper) Sidney Spit, BC 4

(Sea Skipper) Sidney Spit, BC 3

Aft steering station – ZF electronic engine controls

(Sea Skipper) Carabineers are attached to pre adjusted fender whips and are in turn clipped to eye loops above rub rail - one showing below name.

View Aft(Sea Skipper)

(Sea Skipper) *

(Sea Skipper) Computer navigation station connected by serial cable to network NMEA data

(Sea Skipper)

(Sea Skipper) Galley unit – Wallas stove located toward front of cabinet leaves space for microwave behind. Microwave raised 1" so door can be opened over stove top.

(Sea Skipper) Lavac vacuum head with manual waste discharge pump. 2nd Y valve (hidden behind head) is used to route suction line to a bilge strainer mounted below cabin steps for use as an emergency bilge pump. Head is mounted at a comfortable height on an 8” PVC pipe cap.

Single (window) turn catch located at base of shower door opposite the hinge side will hold lower part of door tight against the sealing gasket eliminating "all" leaks. Several 1/8" drain holes were drilled in the aluminum door frame just above the lower gasket to duct the small amount of water that collects between door and frame back to shower stall. The catch was slightly modified to permit opening by screw driver from the outside if necessary and for correct spacing.