cutting out the drain for the livewell
Viewed: 425 times.
|
sealing up the holes. Part of this flat area will be cut out for the tank inserts
Viewed: 313 times.
|
|
1708 and chopped strand mat. polyester resin
Viewed: 282 times.
|
could not get it off, so had to drill a hole and pop it off with an air nozzle
Viewed: 323 times.
|
mdf was a bad idea. and prying on it was also a bad idea
Viewed: 313 times.
|
hope it will last for one more part! I now have a hole drilled in the mold for part removal
Viewed: 278 times.
|
used a different combination of glass for the 2nd part. it was a lot lighter, but plenty strong still. it was easy to demold with the rubber tipped air nozzle
Viewed: 294 times.
|
layout holes for the tank inserts
Viewed: 283 times.
|
|
one insert in
Viewed: 289 times.
|
both inserts in
Viewed: 282 times.
|
components in, gauge, reg, solenoid, manual shutoff for bbq, and grommets
Viewed: 273 times.
|
finished up, there is a 1/2 hole with a clamshell over it that leads to the splashwell for the drain
Viewed: 299 times.
|
close up of components
Viewed: 297 times.
|
lpg control panel. turns on/off solenoid and an alarm. there is a sensor under the galley
Viewed: 357 times.
|