cutting out the drain for the livewell

sealing up the holes. Part of this flat area will be cut out for the tank inserts

mold

1708 and chopped strand mat. polyester resin

could not get it off, so had to drill a hole and pop it off with an air nozzle

mdf was a bad idea. and prying on it was also a bad idea

hope it will last for one more part! I now have a hole drilled in the mold for part removal

used a different combination of glass for the 2nd part. it was a lot lighter, but plenty strong still. it was easy to demold with the rubber tipped air nozzle

layout holes for the tank inserts

cut

one insert in

both inserts in

components in, gauge, reg, solenoid, manual shutoff for bbq, and grommets

finished up, there is a 1/2 hole with a clamshell over it that leads to the splashwell for the drain

close up of components

lpg control panel. turns on/off solenoid and an alarm. there is a sensor under the galley