New Drawers... each piece was modular and we actually ended up placing deeper drawers on the top parts of a less deep rack (to fit along the angle of the hull). Note: we have now been using these for ~7 years and still love them. They still look and work like new with absolutely no signs for wear or rust.

New Garelick Ladder #19623

Ladder bracket

Name designed using Boat US graphics website. Excellent design website, fast service, and easy to apply. And it looks great!

Galley with corner shower caddy, plate holder and paper towel holder and towel rod/handhold *

Galley with corner shower caddy, plate holder and paper towel holder. Note: we’ve now been using this stainless caddy for ~7 years. It still looks new with no signs of rust. It’s been a great addition in the galley.

2x4 supports for generator platform with brass screws, tops removed

Platform set on, with the brass screws (tops removed)used to hold the platform in place. All 3 pieces are completely separate which allows for easy setup, removal, and storage. Nothing is attached to or screwed into the boat. *

Generator in place and ready to run. Security wire or chain is run through rod holder and locked so it cannot be pulled out.

1" washer folded in half and set on to seat frame. #4 screw used to secure it. Seatback will now be in a more upright position offering better support.

Another view of the washer and seat back position. As needed a 2nd washer can be used on the seat back frame to position it even farther forward. I have made spares for this purpose that I just set in place as desired. In this photo you can also see the new support frame which raised the seat an additional 1 inch - giving better view when piloting.

New 12x24" storage hatch in v-berth. Hatch cover made by T-H Marine.

No foam had to be removed, just smoothed a bit.

Always ready to deploy fender for use in a fishing rod holder. Thanks to Will-C for the idea, based on a photo in his album.

Quick and simple to make and deploy, and especially nice when you have extra fenders.

Yep, an ENO ProNest hammock strung between the 2 stern cleats - which have strong backing plates. I'm 5'8" tall (or short) and fit fine.

over the door mesh organizer reconfigured horizontally

vberth with hammock over clothes organizers over reflective window panels

two under table drawers from campingworld

Drawers had no lock, so we made one... Now we can drop table and nothing falls out.

Finished product, ready to use. The material is made by Lonseal Marine, Teak & Holly 70SE. It comes in a 6' wide roll, cut to whatever length you desire.

Looking aft without forward dinette seat in place. Had to remove it to properly template that area, trim the material, and glue it in place. The hatch hinges will also assist in holding the dinette section in place. The cabin floor section is floating.

Looking towards the bow without the forward sliding dinette seat in place

Small step at helm. This section is also glued down.