The C-Brats Forum Index
Home |  Forums |  My Topics |  Calendar |  Event Signups |  Memberlist |  Our C-Dorys |  The Brat Map |  Photos

 Electronics 
30 images in this album on 2 pages
Gallery: C-Brat Albums navigate UP Album: The CBTech Library navigate UP
First Page Previous Page
 leftdot 1  leftdot 2  rightdot
    
Transducer location preferred inside under Force 10 heater, not pictured.
Transducer location preferred inside under Force 10 heater, not pictured.
Viewed: 1309 times.
carved out with a hole saw and finished with a vibratory power tool with sanding disc and rasp - also shown is the coat of glass and resin to seal it up.
carved out with a hole saw and finished with a vibratory power tool with sanding disc and rasp - also shown is the coat of glass and resin to seal it up.
Viewed: 1144 times.
after feathering it out some to fit the housing perfectly, silicon was recommended to seal, before filling the outer cavity with glass and resin...
after feathering it out some to fit the housing perfectly, silicon was recommended to seal, before filling the outer cavity with glass and resin...
Viewed: 1099 times.
arrg! there it is :D
arrg! there it is :D
Viewed: 1106 times.
filled with antifreeze
filled with antifreeze
Viewed: 1148 times.
about the half-way-point in the Classic hull, works great in this spot for speeds under 13 knots or so.
about the half-way-point in the Classic hull, works great in this spot for speeds under 13 knots or so.
Viewed: 4918 times.
First Page Previous Page
 leftdot 1  leftdot 2  rightdot
    
Gallery: C-Brat Albums navigate UP Album: The CBTech Library navigate UP
Powered by Gallery v1



Page generation time: 1714182392.51s (PHP: 100% - SQL: 0%) - SQL queries: 9 - GZIP disabled - Debug on