old flush mount rod holder location
Viewed: 199 times.
|
need to fill this in a little for the new flush mount rod holder mount
Viewed: 179 times.
|
|
cut out and drilled for the new scotty mounts
Viewed: 179 times.
|
new mount covers all the ugly. the old flush mount tube stuck way down on the underside and was not adjustable for the angle of the rod
Viewed: 173 times.
|
cleaned out the paint and old adhesive so I can put a fillet and some glass in to hold this storage pocket bottom in place. both sides are busted loose on the bottom. factory only uses some kind of adhesive to hold these together
Viewed: 186 times.
|
here is the patch I put over the old raw water washdown thruhull. this time I tried to be more efficient by dishing it out, then glassing, then waiting for that to gel and putting the fairing compound over it before it was cured. most of my time working on the boat has been grinding
Viewed: 211 times.
|
cockpit floor just after gelcoating
Viewed: 210 times.
|
cockpit floor
Viewed: 192 times.
|
transom and under splashwell
Viewed: 192 times.
|
cabin sole
Viewed: 571 times.
|
inside of the transom painted an gelcoated
Viewed: 153 times.
|
under the gunnel shelves had broke loose from the side of the hull. I put a fillet and some glass to reattach and then painted it all up. looks really good now and is solid
Viewed: 150 times.
|
fitting up the new cabinets
Viewed: 150 times.
|
|
|
|
|
|
|
ground off the gelcoat in the areas where Im going to tab in the cabinets
Viewed: 169 times.
|
|
|
this piece of ply is what the wallas 22gb will mount to
Viewed: 150 times.
|