wetting out 1708
Viewed: 534 times.
|
first few layers wet out
Viewed: 227 times.
|
covered with plastic after 8 layers to gel up
Viewed: 220 times.
|
smooshing to get flat
Viewed: 244 times.
|
keeps the board and blocks from leaning and making it uneven thickness
Viewed: 221 times.
|
28 layers 1708 to get 1 in thickness. three 'batches' over 1 day so doesn't get too hot
Viewed: 235 times.
|
cardboard template
Viewed: 232 times.
|
template traced out
Viewed: 218 times.
|
panel cut with 4 1/2" grinder and diamond wheel
Viewed: 220 times.
|
thickened epoxy troweled on and a thick bead along the bottom
Viewed: 237 times.
|
bottom of transom epoxied and braced into place
Viewed: 273 times.
|
prepping the coring
Viewed: 447 times.
|
wetting out the back side
Viewed: 248 times.
|
thickened epoxy troweled on
Viewed: 220 times.
|
applying the coring
Viewed: 216 times.
|
first layer of coring in and topside wetted with unthickened epoxy to soak
Viewed: 221 times.
|
thickened epoxy over first layer
Viewed: 212 times.
|
both layers installed. the solid blocks will be drilled for the engine mounting brackets
Viewed: 208 times.
|
|
bracing to keep the coring against the outer skin
Viewed: 555 times.
|
grinding down sharp edges so the glass can lay down
Viewed: 446 times.
|
this is the corner that had the repair job from some unknown incident
Viewed: 255 times.
|
test fitting the coring
Viewed: 234 times.
|
josie helping out
Viewed: 225 times.
|
Search
Private Messages
Profile
Log in
Register
Help
