1 gallon Diesel jug.jpg

(Nancy H)
Force 10 Propane heater mounted on inside of door

(Nancy H)
Stack made of copper water pipe and fittings goes thru door.

(Nancy H)

Inside of door, stack detail

(Nancy H)
Outside of door, stack detail.

(Nancy H)

Door, stack ends with a tee fitting even with the top of the door.

(Pat Anderson)Beveled rear of floor

(Pat Anderson) Floor removed *

(Pat Anderson) Drawer opened

(Pat Anderson) Drawers in place on floor

(Pat Anderson) Floor under galley

(Da Nag) Sugastune KR-75 slide latches - seat facing rear

(Da Nag) Sugatsune KR-75 slide latches - seat facing forward. Click photo for larger pic and install description.

(Lynn Marie) The carpet is about 5/16" thick with a sizing on the back side. Both sides are the same color but the front is fuzzy and the back is smooth and rough to the touch. Be carefull!

(Lynn Marie) Adhesive used for the project. Can is sitting in front of the 8" wide closed cell sill sealer used under the carpet on the hull sides.

(Lynn Marie) See the previous post.

(Lynn Marie) Carpet project on the Lynn Marie. What I used and where I got it.

(Lynn Marie) Close-up of hull gelcoat & hulliner carpet. Both have similar white and tan colors.

(Lynn Marie) arpet layed over nut/bolt ends and winch backing plate just above rope locker bulkhead. Carpet stretches well over small lumps.

(Lynn Marie)Carpet on cabin roof, side, deck, & hull @ starboard by electrical panel cover.

(Lynn Marie)Carpet at hatch and cabin side.

(Lynn Marie)Carpewt port side at bulkhead/cleat well and where it meets the dash bulkhead

(Lynn Marie) Carpet edge at rope locker with wood trim locker bulkhead extender.

"Hidden" galley. Seating will go over the top. Must be Luna-C. *