corrosion under hinge.

door lock taken apart. The dead bolt is tricky to get out. See next picture. *

dead bolt removed from lock. This must be done to get the glass into the door frame.

Dead bolt is removed by loosening two flat blade screws deep inside the lock frame. Do not remove the screws all the way, just enough to get the dead bolt out.

All went well except for this mistake. I did not mask both sides of the frame before applying the urethane window adhesive. The urethane really grabs the powder coating and is a pain to remove.

This shows the effect of masking. Excess urethane can be easily trimmed from the glass but not the frame. *

Lightbar and reflective tape *

grey water drain attached

grey water part

Raycor Fuel filter

P4220001

SBYC Burgee

reverse

el and bill