Eight weeks of wet sanding, compounding, and polishing top to bottom
Viewed: 261 times.
|
Covered previous holes with large starboard after filling and redrilling holes and rebedding handrails with 5200 to correct cabin roof leaks
Viewed: 190 times.
|
Even got the new skin cleaned and sealed
Viewed: 189 times.
|
Four glide oat applications up to Second plank above water line
Viewed: 197 times.
|
Clean reflection
The snaps hold the bottom edges of the mosquito netting- They’re called “SNADs” and do not require holes to be drilled just prep with their primer. Sailrite carries them
Viewed: 191 times.
|
Close up on SNAD connectors some Al plastic and others steel with flex for corvette mounting
Viewed: 180 times.
|
D8339454-DB03-4E3D-B893-55E761DB6F0F
Viewed: 154 times.
|
C8BF0A9F-D4A1-4667-BD1A-BD398A682421
Viewed: 168 times.
|
A few holes to fill & drill
Viewed: 172 times.
|
Ground a dremmel saw bit fir reaming core from hole sides
Viewed: 173 times.
|
Reamed and ready to fill
Viewed: 169 times.
|
Filled and flush
Taped underside of cabin roof and filled with paper funnel after brushing balsa core with unthickened epoxy
Viewed: 167 times.
|
Holes redrilled perpendicular
Viewed: 149 times.
|
115108E1-99DF-426B-B451-3A6CD73B3EDE
Viewed: 164 times.
|
Working Alone: nuts inside cabin wrench on roof
Viewed: 159 times.
|
Working Alone: bolts from cabin roof. To seal I made a small circle of 5200 on bottoms of flanges and around holes on cabin top. The handrails were suspended just above holes for fine alignment without smearing sealant.
Viewed: 164 times.
|
Since NOTHING will adhere to Starboard, I used butyl tape between the bottom of the holes where they met the cabin top.. tight acorn nuts underneath with fender washers make a durable seal
Viewed: 177 times.
|
C94A34DC-0487-4A91-8220-ECE4B77AFEDC
Viewed: 249 times.
|