Supposed C-Dory 12 (I think it may have been determined that it is really a 14)
Viewed: 1261 times.
|
Supposed C-Dory 12 (I think it may have been determined that it is really a 14)
Viewed: 844 times.
|
|
Garmin Bluechart Data Card, fits in Garmin 2006c and numerous others.
Viewed: 984 times.
|
plain fastener
Viewed: 835 times.
|
shelf fastener
Viewed: 913 times.
|
Brass stem guard dimensions, 2002 22 Cruiser. Where the stem ends aft is where the "keel" starts, so a rubber keel guard doesn't look like it could logically go any further aft.
Viewed: 922 times.
|
Garmin data card packaging, with card sitting on top.
Viewed: 850 times.
|
Under galley showing Wallas exhaust hose.
Viewed: 879 times.
|
89 closure and detour
Viewed: 930 times.
|
Wallas top
Viewed: 941 times.
|
Wallas serial number
Viewed: 922 times.
|
Wallas tank
Viewed: 925 times.
|
Wallas exhaust hose
Viewed: 890 times.
|
Wallas open and control
Viewed: 802 times.
|
Photo used to ask if this is the location of cracks on a different C-Dory that a potential buyer is asking about.
Viewed: 949 times.
|
Slot cut into galley face for Wallas ventilation
Viewed: 878 times.
|
Nicely centered hole for Wallas control (ahem...)
Viewed: 883 times.
|
IMG 6567
Viewed: 918 times.
|
IMG 6568
Viewed: 786 times.
|
Annoyed drain guard
Viewed: 922 times.
|
Garelick operation
Viewed: 1005 times.
|
Not the best photo - I'll try to get a better one in future. This is an alternative method of hanging the after fender. I got the idea from Will-C and wanted to try it since the fender hanging from the after cleat can tend to get aft of the boat. The basic idea is to put some sort of dowel into the rod holder (these were already in my boat) and then hang the fender from it. I started with Schedule 80 PVC pipe (1" IIRC), but didn't really like handling it, so this is an ash tool handle replacement (bought at Ace Hardware). To secure the fender whip to the dowel, I drilled a hole through the dowel, and then run the whip through it and then tie a figure-8 knot. That way it is adjustable if necessary. I left the dowel this long because it then keeps the whip/line off the gelcoat at the edge of the deck.
Viewed: 1074 times.
|
C-Dory cutaway hi res
Viewed: 1139 times.
|