Creature Comforts Made from 50 YO Mahogany.jpg

Factory installed hatch in V-berth. Interior finished like the inside of the hull - smooth (10DEC09).jpg

1x11x23-inch PVC board (scrap) notched to span v-berth opening. Trim is scrap wood teak oiled, glued and screwed in place (14DEC09)

Cushion fits into new v-berth span.Both cushion and span can be lifted out for ease of access to forward v-berth hatch (14DEC09)

1. Table/bench seat fits over transom. Made from scrap PVC planks.
2. Scrap PVC planks cut to fit over raised edges of bilge area. This allows use of bilge area w/o stowing any gear in water

Bilge area used for stowage w/o gear resting in water

Galley area. 2 lift-out boxes made from 50 YO mahogany. Back box holds coffee cups, etc. Side box has small cups from Chuck E. Cheese which holds condiment packets form various fast food outlets.

See through stowage area between seats and port bulkhead. Cut-to-fit piece of wood lays in top to facilitate better use of the area

Center Window Screen (11MAR10)

Cabin light lens off. LED draws .009 amps. Clip off old socket and solder to existing leads. Light mounts to factory frame with marine adhesive. (11MAR10)

Cabin light LED with lens on. Available from Bebi-Electronics, Fiji (2 for $71) (11MAR10)

2-12V Oscillating Fans wired to same 15A fuse block. Draw 1.5A each.(25SEP10)

Cabin view of 2-12V power outlets in cabin. Each wired to separate 15A fuse.(25SEP10)

V-berth view of 12V power outlets.(25SEP10)