"Arm Strong" Trap Puller Puller.Attaches to Pole Holder mounting plate
Viewed: 855 times.
|
Cockpit light
Both interior lights use the "Cabin Light" circuit breaker as a switch
Viewed: 857 times.
|
Cabin Light
Viewed: 902 times.
|
Extended ladder "Stand-offs" with Oak Blocks to spread out weight
Viewed: 850 times.
|
Ladder Closed
Viewed: 791 times.
|
Ladder Open
Viewed: 787 times.
|
New transducer mount using old holes in transum.
Viewed: 961 times.
|
Added Fin
(Before I saw Dave's)
It was almost too much, I had to move the tilt pin out one notch
Viewed: 923 times.
|
Covered radio antenna with blue Shrink Wrap to avoid fiberglass slivers. Now for the "Bottom" work.
Viewed: 1266 times.
|
Coming off of trailer. How to do it alone is in "Things I did on my CD today"
Viewed: 923 times.
|
Coming off of the trailer 6" at a time. From stern
Viewed: 808 times.
|
Stern Dolly. The post supports clear the ground by 1/4"
Viewed: 790 times.
|
Blocked & ready for Skegs and bottom paint
Viewed: 766 times.
|
From stern. Skegs are 16" from keel to clear trailer rollers
Viewed: 894 times.
|
Each Skeg is attached with 5 bronze fasteners
Viewed: 771 times.
|
Skegs are 1"x 2"x 4'Oak attached to hull with bronze fasteners and 5200
Viewed: 752 times.
|
First Coat of bottom paint
Let her dry for a day or so...
Viewed: 694 times.
|
Very close match. White X2 + Blue X1
Viewed: 697 times.
|
The Skegs blended right in
Viewed: 745 times.
|
Trailer adjusted and we're ready for the water
Viewed: 703 times.
|
Arm Strong Power Tilt
Viewed: 718 times.
|
Tilt Handle comes apart to stow
Viewed: 671 times.
|
Tie Rod Moved to the front of the motors. (Where it belongs) it was on the back.I would have had to stand in the water to install it.
Viewed: 799 times.
|
Finally In The Water
Viewed: 1143 times.
|